mini single channel changeover relay module (for standalone and Velbus operation)
Mini 1-channel changeover relay module. Can be used in standalone mode (a push-button operates the relay directly), or in Velbus mode (input and relay are used as configurable Velbus channels)
- 80A high inrush current changeover relay with potential free contacts
- for switching capacitive, inductive or resistive loads
- standalone mode: in standalone mode a push-button connected to the input operates the relay
- momentary or toggle mode can be selected by toggling the slide switch on the back
- Velbus mode: in Velbus mode the module is connected to a Velbus domotics system
- the relay and input are used as Velbus output and input channels
- firmware upgradeable through the Velbus system
- CAN terminator switch with state detection
- bus error state indicated by led flashes
- detection of power supply undervoltage indicated by led flashes (standalone and Velbus mode)
- fire retardant ABS case with cuttable mounting brackets for screws and m3 bolts
- leds for power supply, Rx (Receive), Tx (Transmit) and relay status
- weight
- 34 g
- dimensions
- 37 x 57 x 19 mm (L x W x D)
- temperatura de funcionamiento
- -10 - 50°C
- grado de protección IP
- IP10
- power supply
- 15±3 VDC
- current consumption
- 50 mA (max)
- Velbus and input connectors
- 0.5 - 1.5 mm²
- relay connectors
- 1 - 1.5 mm²
- relay max. current resistive
- 10 A @ 230 VAC / 10A @ 30VDC
- relay max. current capacitive
- 6 A @ 230 VAC
- relay max. current inductive
- 6 A @ 230 VAC
- relay max. power
- 250 VAC